SEAL Image 410 Instrukcja Naprawy Pobierz pdf (Strona 7)

UNPACKING YOUR LAMINATOR

• Remove the transport packing and the plastic

shrink-wrap the laminator is wrapped in to avoid

moisture penetration.

• Remove the accessory kit package from the top of

the laminator, which includes the necessary tools

for installation.

• Remove the footswitch from the top of the

laminator and remove the foam wrapped around it.

• Place the footswitch in a position that is accessible

while feeding images.

• Remove the protective foam wrapped around the

front table.

• Remove the cardboard box containing the wind-up

idler and remove the wind-up idler from the box.

• Install the Wind-up Idler into place on the front

Wind-up Assemblies.

• Cut and remove the tie straps securing the Unwind

Shafts and remove the foam wrap from the ends.

• The top roller will go up automatically when power

is connected.

• Remove the blocks placed between the top and

bottom roller ends.

• Remove the stickers securing the protective paper

on the rolls using your fingers only.

• Then gently pull the paper towards you to unwind

off the roll.

WARNING! DO NOT USE OPEN BLADES

TO REMOVE THE PROTECTIVE PAPER

ON THE ROLLERS.

• Roller damage caused by improper use of cutting

tools will void the user’s warranty. Small cuts and

imperfections in the rollers greatly affect the quality

of the output and roller replacement costs are

expensive.

LEVELING YOUR LAMINATOR

• Use the open-end or adjustable wrench to turn the

transport bolts down until the bolts are positioned

flat against the floor.

• Insert a 3’ x 1’ (91cm x 30cm) piece of foam board

across the center of the laminator lengthwise

between the top roller and the back table and place

the level in the center on top of this foam board.

• Adjust the leveling feet for each side cabinet until

level.

• Next, place the level sideways on the piece of foam

board and adjust the leveling feet from the front to

the rear of the cabinet as needed.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag

SEAL Image 410 Instrukcja Naprawy Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Laminatory SEAL Image 410