SEAL Image 410 Instrukcja Naprawy Pobierz pdf (Strona 24)

PRE-COATING BOARDS

This process is used to coat substrates with a self-

adhesive coating onto which images can be mounted.

Images can then be mounted on the substrate. This

same process is used to create a sled.

PREPARATION:

IMPORTANT! Ensure that the Nip settings of the

rollers correspond to the board thickness.

• If desired, set the top roller’s temperature to 120°

(49°

C). Using heat assist may improve the adhesive

bonding of the laminate.

• The bottom roller temperature is OFF.

• Load the roll of pressure sensitive adhesive onto the

top unwind shaft of the laminator with the exposed

adhesive facing out.

• Use a leader-board of the same thickness as the

boards to be coated.

• Pull the adhesive down from the top unwind shaft

and place evenly across the face of both rollers.

• Press the foot switch and using the leader -board,

push the adhesive into the roller nip

• Release the foot switch when the rear edge of the

leader-board is almost leaving the roller nip.

• Position the board to be coated into the nip, behind

the leader board and choose a speed setting. Press

the motor switch ON or use the footswitch to

process the board.

NOTE: When coating boards, ensure that the next

board to be coated follows the previous board

without any gaps.

NOTE: Follow the last board being coated with the

leader-board again to allow the final board to clear

the laminating rollers and then stop the motor and

raise the top roller.

Substrate

Adhesive

Figure 17. Pre-Coating Boards

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Brak uwag

SEAL Image 410 Instrukcja Naprawy Strona 24